MULTIQ 219 TOUCH DRIVER

MULTIQ 219 TOUCH DRIVER

Pressing it again will turn it off. You’re covered by the eBay Money Back Guarantee if you receive an item that is not as described in the listing. Always use the appropriate AC cord that is certified for the individual country. TTL Level, ohms Sync. Read more about the condition.

Uploader: Akinojora
Date Added: 4 September 2011
File Size: 30.2 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 53403
Price: Free* [*Free Regsitration Required]

Please connect all cables to the back of the monitor before mount the VESA metal to it.

Not available selections will be grayed out. When no operation is done for around 60 seconds default OSD timeoutit goes back to the stand-by mode and no more switching is accepted except [MENU] to restart the setting. Please consult the table below for the selection criteria for power cords used in the United States and Canada.

To prevent overturn when moving, transport the equipment on flat surface only. Shielded interconnected cables and shield power cords must be employed with this equipment to insure compliance with the pertinent RFD emission limits governing this device.

It may not function properly if any of the following applies: Check that power cord of the Computer or AV device has been plugged securely into wall outlet.

Keys do not work properly?

Time settings are adjusted from the system unit by software. Please consult section 7 for OSD screen adjustment procedures. Troubleshooting Tips In the 2119 that you experience trouble with your Monitor, check the following items before contacting the dealer from whom the Monitor was purchased.

  LITEON LDW 451S DRIVER DOWNLOAD

MQ219 Touch Signage Monitor

Check that Video Cable from the displays has mulhiq securely and correctly connected to the pin Video Connector at the rear side of the computer or AV device. This type of cancellation will not save the previous changes. Install Monitor on a solid horizontal surface such as a table or desk.

Serial or USB cable kultiq Operation: Check that Video Signal Cable from the Monitor has been securely and correctly connected to the Video Connector at the rear side of the Computer. If other video modes are used, the monitor will stop working or display unsatisfactory picture quality.

If you find that any of these items are damaged or missing, please contact your dealer immediately. Check that Graphics card is firmly seated in card slot of Computer motherboard. The socket-outlet should be installed near the equipment and should be easily accessible.

MQ Touch Signage Monitor

It’s a community-based project which helps to repair anything. Live If the coloured wires of the mains lead of this appliance do not correspond to the coloured markings identifying the terminals in your plug, proceed as follows: If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measure: The item may have some signs of cosmetic wear, but is fully operational and functions as intended.

  LOGITECH QUICKCAM FOR NOTEBOOKS MAC DRIVER

This listing has ended. The bottom line of the main menu shows information for the selected function.

MultiQ MQ Touch Screen Signage Monitor | eBay

The selected item is highlighted as the scrolling moves along. For additional information, see the Global Shipping Programme terms and conditions – opens mulitq a new window or tab This amount includes applicable customs duties, taxes, brokerage and other fees. TTL Level, ohms Sync. Learn more – opens in a new window or tab Postage: Learn more – opens in a new window or tab. The cord set must be selected according to the current rating for your unit.

Read more about the condition. The graphics card must also be set up correctly in Windows and make sure the video output of the graphics card is listed in Section 6.